This adapter does everything the SATA hard drive to IDE Converter or IDE drive to SATA Host Converter. This is a two-stage converter for serial and parallel ATA translation.
This includes a serial ATA PHY, a link, a transport, and a parallel ATA (application layer) controller.
Serial physical, references and ATA transport layers correspond to serial ATA I / II.
This converter supports 3 GHz data rates.
With LED indicated power
Easy to install and no driver needed.
Serial ATA 1.0 / 2.0 Specification
ATA 1.5 Gb / s speed negotiation
PIO ATA / ATAPI 0 to 4 mode
ATA / ATAPI Ultra DMA transmission speeds 16.7, 25, 33, 48, 66, 100, 133, 150, 300 MB / s.
Address node ATA / ATAPI LBA48, associated with a 2-byte sector
Serial ATA hot-plug support
Very low power consumption
Work for both AC and DC between transmitter and receiver
Provide specified OOB signal detection and transmission
Spread spectrum support to reduce EMI
Support partial / dormant power management
Provides TX signal amplitude adjustment and pre-emphasis level